Gary Jensen SS 5 Degree headers for NR and other 7/8" opening Pipes

[Bill Brandt]

What you've been wanting. Gary Jensen SS 5 Degree headers to the side made for Novarossi Pipes and others with a 7/8 pipe ID. This header has a 7/8" OD. I removed the inside coating in the pipe neck and this telescopes in very nicely. Use the supplied silicone rubber for a good air tight fit. Great for through the transom application. Regular price will be $64.95 but I'm putting on an introductory special at $54.95. Guaranteed satisfaction. Open up, put it on your motor without starting and if you're not 100% happy return within 10 days and I'll refund your purchase price. On our CMB 67 and 80s I think we still are using the sisters to these for 15 years. Look for these at https://www.allrc1.com/product-page/gary-jensen-5-degree-pipe-for-nr-and-others-with-7-8-id-opening

 

[rctinman]

Hi Bill..

Do you, or someone else, sell the same header, but with a smaller diameter pipe, say 3/4"?

Thanks,

Steve Ball

 

[Bill Brandt]

Hi Bill..

Do you, or someone else, sell the same header, but with a smaller diameter pipe, say 3/4"?

Thanks,

Steve Ball

Steve, Here's the same one in the smaller diameter.....https://www.allrc1.com/product-page/gary-jensen-5-degree-cmb-67-80-header-assy

 

[rctinman]

Hi Bill..

Do you, or someone else, sell the same header, but with a smaller diameter pipe, say 3/4"?

Thanks,

Steve Ball

Steve, Here's the same one in the smaller diameter.....https://www.allrc1.com/product-page/gary-jensen-5-degree-cmb-67-80-header-assy

Bill, could you tell me the diameter of this one? I need 3/4".

Thanks,

Steve

 

[Bill Brandt]

Hi Bill..

Do you, or someone else, sell the same header, but with a smaller diameter pipe, say 3/4"?

Thanks,

Steve Ball

Steve, Here's the same one in the smaller diameter.....https://www.allrc1.com/product-page/gary-jensen-5-degree-cmb-67-80-header-assy

Bill, could you tell me the diameter of this one? I need 3/4".

Thanks,

Steve

My caliper reads .752 OD and .682 ID so I believe thats 3/4 OD

Thanks

Bill

 

[rctinman]

Great Bill, I'll get one ordered.

Thanks,

Steve