- Joined
- May 25, 2004
- Messages
- 1,254
Hi guys,
I've got an old RX-21 engine that was converted to an outboard and I could never get it to shut down on the bench / coming off the water. I knew it was pulling air from somewhere and later realized it was breathing through the front bearing, turns out the hole going from the intake to the front bearing isnt plugged like it should be.
I want to plug it back up and was wondering what i should use. I was thinking either a dowel pin or just some JB weld? Anyone done this before?
Brian
I've got an old RX-21 engine that was converted to an outboard and I could never get it to shut down on the bench / coming off the water. I knew it was pulling air from somewhere and later realized it was breathing through the front bearing, turns out the hole going from the intake to the front bearing isnt plugged like it should be.
I want to plug it back up and was wondering what i should use. I was thinking either a dowel pin or just some JB weld? Anyone done this before?
Brian
Last edited by a moderator: