- Joined
- Oct 2, 2005
- Messages
- 7,739
Offering for sale, a Seaducer 20MONO SD3 33" version with a CMB RSV07 21 engine
This was a slightly damaged hull (a little prop walk accross the deck) I took on trade for some paint & body work.
Repaired the damage & painted the deck with Dupont Imron red, and PPG Concept yellow. Cleared with Dupont Imron 500S with pearl dust in the clear.
Engine is from Mark Bullard, still plenty tight. with CMDi remote needle. Mac's 3.5cc nitro pipe, with internal stinger muffler
Home made shaft oiler installed.
Will come as pictured, 100% ready to run, all three servos (mixed bag, Hitech & Futaba), TX (Futaba 3PDF) & RX (Futaba) and 5cell RX pack
shaft & prop X440/3
Please reply here to post,,, then send PM to specifics
Looking for $550.00 shipped (please PayPal as gift)
This was a slightly damaged hull (a little prop walk accross the deck) I took on trade for some paint & body work.
Repaired the damage & painted the deck with Dupont Imron red, and PPG Concept yellow. Cleared with Dupont Imron 500S with pearl dust in the clear.
Engine is from Mark Bullard, still plenty tight. with CMDi remote needle. Mac's 3.5cc nitro pipe, with internal stinger muffler
Home made shaft oiler installed.
Will come as pictured, 100% ready to run, all three servos (mixed bag, Hitech & Futaba), TX (Futaba 3PDF) & RX (Futaba) and 5cell RX pack
shaft & prop X440/3
Please reply here to post,,, then send PM to specifics
Looking for $550.00 shipped (please PayPal as gift)
Last edited by a moderator: