FE / 3.5 TUNNELL HULL SET-UP BOARD

[JSCARPINO]

Hello All

I have designed a Set-Up board for FE / 3.5 Tunnel Hulls.

It is 11 1/2" wide x 34" long x 3 1/2" high off table.

I have made the CoG bar adjustable from 3" to 9" from the Transom.

I have engraved a line across to measure and set the CoG Bar and to line up the transom to.

I have engraved 2 short lines to line up the inside of the tunnel areas of the hull.

Included are (2) 12mm, (3) 6mm & (3) 3mm shims to place under the lower units cavitation plate

to be able to set the lower unit perfectly flat and 90 degrees to the hull & also adjust the correct height

of the lower unit in relation to the bottom of the sponsons.

 

It really makes set-up a lot better and more accurate.

Items shown in pictures 06 & 07 are not included.

 

$105.00 plus S&H

 

 

[SeanKewley]

Brilliant and sleek!

 

[Rokieboater]

Sweet job Joe.

Not just for electrics...

I wanted to talk to you about a set up board for my riggers. Nikalus had a sweet one on here that I was hoping you could copy and build out of you black composite material.

http://ne-stuff.blog...aoa-charts.html

Let me know if you can do it for me. Looking for one I can stick in the trailer and take with me.

Robert Holland

 

[JSCARPINO]

Sweet job Joe.

Not just for electrics...

I wanted to talk to you about a set up board for my riggers. Nikalus had a sweet one on here that I was hoping you could copy and build out of you black composite material.

http://ne-stuff.blog...aoa-charts.html

Let me know if you can do it for me. Looking for one I can stick in the trailer and take with me.

Robert Holland

I realized that it it is not only for electrics but 7.5 Outboards fit on it too.

I am going to design one for Sport Hydros & Riggers....

Thanks

Joe

 

[Rokieboater]

Sweet job Joe.

Not just for electrics...

I wanted to talk to you about a set up board for my riggers. Nikalus had a sweet one on here that I was hoping you could copy and build out of you black composite material.

http://ne-stuff.blog...aoa-charts.html

Let me know if you can do it for me. Looking for one I can stick in the trailer and take with me.

Robert Holland

I realized that it it is not only for electrics but 7.5 Outboards fit on it too.

I am going to design one for Sport Hydros & Riggers....

Thanks

Joe

Joe

Did see the one on the link I sent you??

Robert

 

[JSCARPINO]

Sweet job Joe.

Not just for electrics...

I wanted to talk to you about a set up board for my riggers. Nikalus had a sweet one on here that I was hoping you could copy and build out of you black composite material.

http://ne-stuff.blog...aoa-charts.html

Let me know if you can do it for me. Looking for one I can stick in the trailer and take with me.

Robert Holland

I realized that it it is not only for electrics but 7.5 Outboards fit on it too.

I am going to design one for Sport Hydros & Riggers....

Thanks

Joe

Joe

Did see the one on the link I sent you??

Robert

Yep...I am going to change it up some, but its a great starting point....

You going to go to Scottsdale, Arizona for the FE Race at the end of Feb.

 

[Rokieboater]

I want to go but really busy right now. Its gonna be a last minutes decision. I have made hotel reservations just in case.

Robert