For Sale -- 1990 wood Hot Shot sprint with a 1990 #5101 11cc K&B outboard. I built this boat back in 1990 and ran it all stock only about 6 times. I was tossed out of a couple of my local lakes for noise and disturbing the ducks so it went on the garage shelf for 14 years untill about a year ago. When I dug it back out. Even though it had after run oil in it it felt gritty so it got torn down and all 4 of the bearings replaced with ceramic. While it was apart I had it painted with 500 degree ceramic paint, modded a new lower unit for the new 707 header and new Silver Bullit pipe (both are un-cut), had the sleeve ports modded, installed a new Nitro watersports propshaft kit, added a new High-Jacker mount, 707 throttle cable bracket. Now it will just sit again because I would rather take the bass boat out and fish so it must go to somebody with time to finish it. The hull has a 14oz tank in it but the radio and servos need to be installed. The hull is painted with PPG yellow with red and blue pearl and is ready for your own graphics. There is 1 small crack at the seam where the top deck meets the cowl side at the rear but does not affect the structure of the hull. I still have all the original paper work, boxes and reciepts for the hull and engine. Included with this boat are many extras and accessories.
Accessories included are as follows --
Hobby Shack High torque deluxe starter
Extra Nitro Watersports propshaft kit
Dubro prop ballancer
Futaba Magnum JR radio
Cirrus CS-234 1/4 scale steering servo
2 Futaba FP-S148 servos
New unopened Racers Edge rechargable glow igniter (RCE10561B)
Six Shooter hand crank fuel pump
Extra parts are as follows --
Hobby stuff waterproof pushrod seal kit #HSM102
Prather S-245 stainless prop - un-cut
2 Octura X455/3 props - un-cut
Stock Octura 457 plastic prop
New later model 11cc carb
1" long extention and velocity stack with side pressure fitting ?
New K&B 11cc connecting rod #5321
4 New K&B #5149 wrist pin clips
2 New K&B #5145 11cc rotor shafts
New K&B #5144 rotor
New K&B #5123 11cc .002 sleeve shim
New K&B #5197 11cc carb barrel
1 new and 1 used K&B #8751 propshafts
New K&B #8778 11cc high RPM front bearing
2 New K&B #7739 fittings
New K&B #8367 fitting
Good used K&B #5106 11cc combustion chamber
Good used K&B #5105 cooling jacket
New K&B #5216 needle valve
3 new Du-bro 8-32 #539 pressure fittings
3 new K&B #5108 11cc wrist pins
New K&B #5194 head shim kit
6 new K&B HP long reach glow plugs
New thunderbolt short glow plug
New Fox std long glow plug
Prather pushrod kit with links etc.
New roll of Aeromarine radio box tape - 216ft
Misc mounts and hardware
I am looking to get $400.00 shipped to your door in the USA
Accessories included are as follows --
Hobby Shack High torque deluxe starter
Extra Nitro Watersports propshaft kit
Dubro prop ballancer
Futaba Magnum JR radio
Cirrus CS-234 1/4 scale steering servo
2 Futaba FP-S148 servos
New unopened Racers Edge rechargable glow igniter (RCE10561B)
Six Shooter hand crank fuel pump
Extra parts are as follows --
Hobby stuff waterproof pushrod seal kit #HSM102
Prather S-245 stainless prop - un-cut
2 Octura X455/3 props - un-cut
Stock Octura 457 plastic prop
New later model 11cc carb
1" long extention and velocity stack with side pressure fitting ?
New K&B 11cc connecting rod #5321
4 New K&B #5149 wrist pin clips
2 New K&B #5145 11cc rotor shafts
New K&B #5144 rotor
New K&B #5123 11cc .002 sleeve shim
New K&B #5197 11cc carb barrel
1 new and 1 used K&B #8751 propshafts
New K&B #8778 11cc high RPM front bearing
2 New K&B #7739 fittings
New K&B #8367 fitting
Good used K&B #5106 11cc combustion chamber
Good used K&B #5105 cooling jacket
New K&B #5216 needle valve
3 new Du-bro 8-32 #539 pressure fittings
3 new K&B #5108 11cc wrist pins
New K&B #5194 head shim kit
6 new K&B HP long reach glow plugs
New thunderbolt short glow plug
New Fox std long glow plug
Prather pushrod kit with links etc.
New roll of Aeromarine radio box tape - 216ft
Misc mounts and hardware
I am looking to get $400.00 shipped to your door in the USA
Last edited by a moderator: