MarkScott
Well-Known Member
- Joined
- Oct 5, 2014
- Messages
- 3,087
Bought some boats from an estate sale. Will be doing some rebuilds of a couple of these during the winter. First up is a Delta Force 25" mono. Everything that was on the boat was stripped off. After some time cleaning up the inside of the transom, 1mm carbon fiber was epoxied down for a clean surface. Attempted to fill the drilled holes.
Plan on going 4S, Hobbywing 120a esc, have many motors to pic from, most likely start with a Leopard 2200kv. The hardware shown is what came with the boat. I'm wondering if the strut is too long and/or rudder bracket not long enough. Boat did not have trim plates mounted. Does this boat need them? Back to the strut, I was under the impression that D-V's like to have the strut slightly to the right of center. This boat was setup to the left. Before I start to drill holes, what is the best place? Prop?
Any help this outboarder would appreciated the assistance.
Plan on going 4S, Hobbywing 120a esc, have many motors to pic from, most likely start with a Leopard 2200kv. The hardware shown is what came with the boat. I'm wondering if the strut is too long and/or rudder bracket not long enough. Boat did not have trim plates mounted. Does this boat need them? Back to the strut, I was under the impression that D-V's like to have the strut slightly to the right of center. This boat was setup to the left. Before I start to drill holes, what is the best place? Prop?
Any help this outboarder would appreciated the assistance.
