A
Allen Burns
Guest
I have a question on the settup of this motor. I am totally lost. I have run piccos forever and have never had this much problem getting them to run right.
I have this motor in a outrigger with a abc h31 prop. The pipe is at 11 inches from the plug to the weld on the pipe. (cmb pipe). My proplem is that when I set the needle at 2 turns out the motor runs OK for a half lap, then dies. If I richen it up a 1/4 turn it won't come up on the pipe. If I lean it at all it dies as soon as I give it more than half throttle. Have tried different plugs (McCoy 9, K&B,) Fuel is 50% O'donnell.
I just can't figure this one out. Would run my picco still, but I am afraid to hurt it and not be able to get parts.
Any help would be great.
Allen
I have this motor in a outrigger with a abc h31 prop. The pipe is at 11 inches from the plug to the weld on the pipe. (cmb pipe). My proplem is that when I set the needle at 2 turns out the motor runs OK for a half lap, then dies. If I richen it up a 1/4 turn it won't come up on the pipe. If I lean it at all it dies as soon as I give it more than half throttle. Have tried different plugs (McCoy 9, K&B,) Fuel is 50% O'donnell.
I just can't figure this one out. Would run my picco still, but I am afraid to hurt it and not be able to get parts.
Any help would be great.
Allen