Carbon .21 pipes

Intlwaters

Help Support Intlwaters:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Andy Brown

Well-Known Member
Joined
Feb 8, 2003
Messages
2,657
We have used them in 21 rigger and outboards. Do they survive in the environment of a 21 mono?
 
Andy,

I've run a carbon 3280 and a square wave pipe in monos before. I've never experienced any delamination of the pipes. Can't speak for any of the SPP pipes.

I do feel the carbon pipes are more "heat" sensitive and that sensitivity gets multiplied while running in the confines of a mono.

Just my opinion,

Andrew
 
As the maker of the square wave pipes, i would not recommend running in an enclosed mono. My pipes are cured for 8 hours at 425°, so they ate about as hard as any epoxy chemistry can give.

Sent from my SM-N920V using Tapatalk
 
I've been running a carbon squarewave pipe in my mono since 2011 and it works great. The motor is so low in the hull it's mostly blocked from any air passing over it too. It gets toasty but its held up great.

Brian
 
Last edited by a moderator:
S.P.P not a problem Andy, I use to run one in 21 mono and Ian has been running one in his 45 mono for years..
 
Last edited by a moderator:
Back
Top