3.5ss on a Leecraft hull...what prop

[teddy dauphinee]

I need to know what prop I should be putting on my 3.5 leecraft with a modded K&B 3.5ss motor

Anyone with help would be greatly appreciated.

 

[ozbryan]

Teddy theres a range you could try x438 x440 x442 m440 1440 40x52 437/3 440/3 they will all work differently depending on your set up. Personally i would be starting with an x440 or an m440

 

[dave roach]

abc 40/52 is a three blade , I would try a 40/53 two blade.

Dave Roach

 

[LarryConrad]

Mine runs really well with one of Mark Sholund's 1440 back cut props. I'm running a Mac on a K&B lower unit.

Larry

 

[SayMikey]

Mine runs really well with one of Mark Sholund's 1440 back cut props. I'm running a Mac on a K&B lower unit.Larry

Call Gary Preusse and get the Mark Anderson 1440 its good for 45 mph. I ran that setup for a long time....Mike

 

[Mike Hughes]

Call Gary Preusse and get the Mark Anderson 1440 its good for 45 mph. I ran that setup for a long time....Mike

I will second that.

Mike

 

[moparbarn]

45 !!!!!!!!!! try a x-440, tongue cut, cut down to 38 mm-38.5mm. good for 52.6 on gps. ts2, modded k&b, heat trim. i know the m-440 is an x series without the tongue, but my tongue cut x-440's are faster..........

 

[topfuel443]

40X52/3 with a 10 degree backcut and reduced to 38.5mm is a smokin prop if you have a little torque. Dont discount it.... The 40X53 is also a good prop as Dave said

However, its hard to beat a de-tounged X440/M440 for an all around good prop.

~James