Search results

I've been running the stock carb (black with pink) and remote needle valve (black) that came with my 67 greenhead a few years ago. I'm looking to get a new carb and needle that isn't a remote. I run a 1/8th scale unlimited hyrdo but don't race and have found the remote to be more trouble than...

Hi Guys, I need to replace my strut for my 67 CMB powered U-3 and was looking to get the same one that was in the boat currently. I didn't build the boat so I'm not sure where he got the strut. Does anyone know what make this is or where I can get the same part for replacement? Also, I lost...

I have a CMB .67 Greenhead in my 1/8th Scale U-3 Chrysler Jeep. I have the stock remote needle valve opened one turn for the servo arm. Currently I am running 40% nitro, as I do not race. I was wondering how many turns to open the hex head of the needle valve. More details below. I have been...

Just finished up everything on the fake Allison engine. Figured I'd post pictures since I haven't seen this hull up here anywhere yet.

First time I've had a .67 CMB Greenhead. Just wondering what percent nitro to get for it. My local shops only go up to 40%. Is this ok? I won't be racing the boat at all, just cruising around. I just want it to be reliable and I don't need the extra mph.

New to 2.4 GHz radio system on boats. I have a Futaba and was wondering if I could run the antenna inside the hull about even with the deck. I use an antenna inside a .60 size airplane and have had no problem. Can I run the antenna on the inside or should it be exposed? If so, how much length of...

I have an old 1/8th Scale Steve Muck Hull that I would like to get rid of. It is a Ron Jones Hull and I had planned to make U-13 Anheuser Busch or Notre Dame with it. The engine mounts, strut, stuffing box, rudder, and radio box walls are all installed. The cowls are from Troy McIntire. The nose...

Hi, I'm looking for a 1/8 scale Gale V. Either the 1958 or 1960. I would like to get it RTR if possible, I know it would be expensive but that is ok. Does anyone have a Gale V that they would like to sell? Does anyone know someone who makes the Gale V? Thank you

Just was wondering if anyone knew where I could get a waterproof servo. I am going to be mounting it near the transom and I saw that futaba makes a metal gear, water resistant one but it says Not Waterproof. Also, I need to buy a transmitter and receiver, want to get 2.4 GHz and was leaning...

Have a new CMB .67 greenhead. Had K&B .67 years ago with standard, basic carb/needle valve setup. I need help on how to setup the remote needle valve with this motor. Also, which adjustments affect the low and high speed idle? No manual came with my CMB and I was wondering if anyone has a...

I've only had one other .67 motor and it was a K&B. I was taking apart my new CMB 67 greenhead to make sure there were no flashings in it before I started it. After I removed the water jacket, it seemed very difficult to remove the engine head. On my old K&B, the head just came off once the...