Search results

Has anyone use the 21 Zipkit pipe on a sport 21?? If so how did it do and where is a good measure starting point? Thank you

🦅🏁

Look for one or two H2 props Thanks.

Was looking through eBay and saw this boat. Does anyone know what hull this is? It was sold before I could get anymore info. Just a cool boat with it looking like a GP boat.

My U-10 Winston Eagle.

I'm redoing this PT Sport 40 and have and question. Where the strut and rudder would be are a lot of holes. Should I put epoxy in the holes and redrill new holes or epoxy a piece of wood in or fiberglass/ epoxy??

I’ve been searching for this part to adjust the front canard on a scale project. Can somebody point me to a site to get these or know what this part is called. Thank you!

I purchased a speed master rudder and I switched the arm over to the right side for my sport 40. Unscrewed all 3 hex screws and now I can't get the arm to lock in place. It has play in it an I tighten all the screws back. Any help or suggestions would be helpful.

Before I go cutting, I would like some advice on what would be the best way to cut and fix this sponson. It's my first time doing and big repair. Any help it appreciated.

Going to test my PT SS21 an I have a ops 3280 and a AB Parabolic pipe. Motor is a Mac 21. What is a good length for these two pipes??

A person is selling this boat and was told it is a Steve Muck hull. Just want to see if it is or not.

My brother is running a Picco EXR Blue head in his Phil Thomas Sport 40. We were running the back up motor and the setup from the first motor. It did not want to get up in pipe and up to speed like the first motor. We started out rich and lean it each time out and still it would go some what...

Looking for a Octura X646/3 if anyone as an extra. Thanks

I removed the decals off my Sport 40 an I believe the decals were cleared over. How would I get rid of the lines from gel coat surface?

.delete

I bought this Sport 40 on Ebay and was described as a Dave frank 40. It is 35 1/2 in long and 18 1/4 wide. I've done some searching and Dave made his boat from wood. Everything looks to be a Dave hull but this is a fiberglass boat. It's a cool boat either way.

What would be a good pipe length for a muck 67 pipe that is for a scale?

Anyone have one used or new. Figure I would try here first before I would have to order a new one from AC models. Thanks.

I have a AC Sport hydro an had to fix the cowling and going to paint it. Also have a Sport 20 that is Gel coat finish I want to paint. Would I just sand the top surface up and paint over it or is there something else I should do first?

My brother had this motor in a pile of others and wanted to see what Rossi motor it is and is it a good running one? Might fix it up and put it in a Sport 20 boat.