Search results

Looking for source of thin wall fuel hose. 3/32ID and 5/32 OD. Or in metric 2,5mm ID and 4mm OD. Bonus if there is in Europe. Anders

Does anyone have the STD timing on a VAC21? Exhaust, Boost, Transfer? Flat or dished piston? //Anders

I have some Engines for sale. 6pc. K90 Engines (1 is NEW ) 3 has new piston/sleve one has just been run1-2 lit since new piston/sleve and one is used. Try and sell as a batch and it will include 2 boxes of parts. 1500 USD 1pc. OPS 80 Little run time (2-4 lit). Mounted a CMB 10mm carb on a...

Is the date determined for the 2017 Winter Nitro Nats? See if it`s possible to visit?? Anders

How is it going with the planning of winternats 2013?? Regards Anders

Where can i buy 7075-T6 alu sheet by the square feet in 0,06-0,08" in the orlando area? Anyone have a web page?? Anders

Does McCoy have a homesite???? Anders

Anyone that have a Muck 90 pipe to sell?? Anders

Is there anyone that has Ed`s Phone number?? PM me. Anders

I have a question about pipe "funktion". On one of my 45 boats i have a qiute bad sling shot effect. It goes very rich in low and medium rpm but when the pipe start to "pump" it just accelerate untill it runns lean and burn the plug. I know that there was a topic along time ago that the...

Just wonder if someone knows what the tub angle should be?? I have 81mm in the back and 76mm at the sponson ride surface (5mm down angle on the tub). Is that ok or to mutch?? The manual dosen`t say anything about that. Anders

http://www.smru.se/ Anders

I wonder if someone knows what the weight is on a OPS 67 piston/wristpin/needle conrod assy??? In grams and one decimal?(if possible) Anders

Does anyone have the values for the CMB91RS engine to put in EAP?? Also STD timings? Anders

I`m going to test this pipe in a rigger and the question is what length is a good start?? I have tested the 1040 or 1240 before and is it the same length with the 1349?? Have anyone compered these pipes and/or what is the differences???? Going to use A-45, K-45 and MAC 45 engines to test it...

Here guys,i can give you a sneek peek of the mono that i have built this winter :) . I will go out and test run it for the first time 1:st of May. It`s a upscale of the "Wildthing" that John Finch have drawn. There is a K90 with a MUCK 90 muffled pipe that will pull a Octura X467. The worst...