Search results

Id like to mess around with some pink foam & make some sponsons. Iv got a hot wire set up. Is the any info out there on the net to help me with the template procedure? Or how do you prefere to make them? Thanks Mike

One more newbie question.. ??? ;D My rigger will be painted inside & out. I dont want to have to drill out any holes after painting & "open" the paint job. How much bigger do you drill the hole to allow for paint? And.. I have many threaded holes also. 4-40 carb shield & cowl mounts. #8...

Iv heard that you should wash cured west systems epoxy with soap & water between coats. But I have some hollow sponsons which recieved water last time I did that (through a few pin holes) and took a week to dry out : :) Would laquer thinner work just as well? Its a epoxy hull.. Thanks Mike

Has anyone tried this fusion paint? Its for flexable plastics so I though it might work on my epoxy rigger. Gas proof? Thanks Mike

Iv been working hard to get a epoxy rigger ready to race, & am close with all holes drilled & everything straight & ready to put together fast. But after sanding for three days Iv uncovered pin holes which go clear through the hull & sponsons Id have to guess at least 200 holes. 1/2 of them...

Im designing a rigger to replace my wrecked one. Im now addicted to the speed of riggers so my interest for my cat & mono is low. Problem is... The area I run on half the time has 2"- 3" rollers and my last 44" rigger did the sponson dance at high speed. What design characteristics make a...

Hi Guys.. Im searching the sites I know for some design ideas & have found some good ones here but most of the pics wont load. Old thread. Could someone provide some pics or links to the hammerhead design & constuction please? Why is the right 20% wider? And is that 2 cm instead or 2mm? And...