Search results

I will give $200 for the OS . 21 OB

Thanks for all your help, it turns out I needed a few more parts. I got Stu Barr to send it all to me. Thanks:

Must be either new or like new. Thanks

Thanks Samuel

I bought this boat from Phil M. Dec 29th (Good Vibrations). Need a like new condition turn fin. Thanks Mike

I will give $475 for it.

Thank you so much Jeremy. I appreciate your quick response. Mike

I need to know the pipe length for a 42in Seaducer, surface drive using a CMB 67 HR. Any info would be a big help. Thanks Mike

Thanks: I got one from Aeromarine, and yes it is a bit of an overkill, but the boat was already setup for a 1/4 shaft. Mike

I need 4 for a OS 21 outboard engine 130mm long Mike

Flex collet to fit 1/4 fine threads and 1/4 flex shaft. Thanks

The OD on the engine is .75 inch and the ID on my header is .91 in. Thanks John

I need a exhaust header for a old Picco 45, the angle need to be close to 20 degrees

I have a old ops 45 and the bearings are loose in the front housing. If anyone has a good one or a new one please let me know. Mike

I know it is a little overkill, but I bought this boat at a race in Atlanta this spring, the hardware is setup for a 1/4 shaft for some reason. 3/16 would be better but I don't wont to change the hardware. Mike

Sounds good would you by any chance have the drive coupler to fit the picco 45? If not I still need the shaft. Mike

Sorry it took me a long time to get back with you, I had some boats to get ready for the Atlanta Race This weekend. I need the flex shaft coupler and 5/8 tubing as well. I have attached a drawing of the shaft I need. Mike Prop Shaft.pdf

I was trying to save you some shipping but yes that will work, just let me know who to get it from.

Are you going to the boat race in Atlanta this weekend, if so I could pick it up then.