Hi guys,
Thinking about doing something with the hobby again.
Hence looking to buy a:
Zoom carburetor for .21 engines in the novarossi style mounting
(shipped to the Netherlands paid preferably by paypal)
Any one know of one or can help me out would be much appreciated.
Looking forward to...
Lohring,
have you checked the coding behind the program?
if i was programming for engineers i would also make them input the straight measurement.
it is not trust worthy to let people measure the arc length as the might need to resolve to tools with large margins of error.
then if it is...
I've got to ask when building with a rear induction motor (MAC) would the motor location need changing with the slightly heavier motor and the pipe way more backwards? Other then that looking forward to see it go.
And thanks to all who make this design available!
jeroen,
the depth of your rudder might well be a problem as well. 3inch is a depth used for .45 size boats with 60mm propellors.
my rudder is about 3.75" from the bottom of the hull and on high pitch propellors i still have to be carefull not to go on the throttle to quick as it will pull.
Paul,
option1
talk to jack, he got all my old cmb45 GPE parts a while ago and there were two or three in there
I am pretty sure he doesn't use all
but you will need to replace the o-rings.
option2
I have for you a MAC like spraybar plate for which you need to use an in-line needle valve...
chris is absolutely correct lifting and digging in turns is a result of vertical turnfin angle.
normally you align the bend lines of the turnfin to run parallel to the hull
or if your hull is setup incorrectly (and the hull does not run level) you might need a different angle then paralel in...
Jeroen,
could have just called me but anyway,
steering left without throttling down is a real no-no with any rigger as has been said before.
turnfin is as said before angled on outside only at 45degree sharp edge. (sharpness, as long as not ridiculously blunt, is not that much of a factor at...
Tom,
I'm sorry but if you came to a day where the only change is the increased humidity then it is not possible to have to richen your motor up.
air density goes down by increased humidity (humidity=percentage of water vapor contained in the air over the maximum capable water vapor possible in...