Recent content by Milner

Also sent test message to [email protected].

Hi Peter, I sent a test message this evening to "[email protected]". Please let me know if you receive. Brent

Hi Peter, I received your email and sent a couple replies several days ago. Maybe check your spam?. Brent

I figured it out. There is a "home screen" button on the second page of the "accessory menu". That button give the option of toggling "instrument panel" or "normal". I suspect this was a firmware change at some point.

Has anyone had issues getting telemetry data to display on the home screen on a 7 PX? It appears that I don't have the option to enable it as shown in the manual.....the button shown in the manual just isn't there. This is on firmware 10.1. Telemetry is enabled and the sensors are showing...

Does anyone know Frank Kolar? I've got some parts for him, but he hasn't responded to email lately and need his shipping address. Thanks in advance for any help. Brent

What stainless are you using? Some alloys can be heat treated to increase strength and hardness. But some can't, like 303 and 304.

Alan Terry?

All, I stumbled across this thread and wanted to add information about my encounter with "[email protected]" and "[email protected]". I'm the guy that makes the Solid Flex Drives. Last March [email protected] contacted me looking for a drive setup for an ML Boatworks 1/8...

I had the same issue when I ran a setup like that. When using that style pipe there needs to be a pair of mounts offset from the center of the pipe to constrain it against rotation. I welded a tube to the side of the pipe into which a piece of ~1/8" wire fit, then attached the other end of the...

rubber edge trim I use #8507K42 on my Whip GV cowl. Just glued it on with weatherstrip adhesive or CA. I wouldn't think the silicone method would hold up well in a gas boat since silicone and gasoline don't play nice together. Brent

I'll throw this guy out too...Traxxas bellcrank

Thanks, Mike. I'm using the standard logger too. I'll have to dig deeper into my battery issue. I'll check out your pictures. Brent

Mike, it sounds like you're running the logger off your RX battery, correct? Are you using a 4-cell battery? My logger seems to not like 5-cell packs. It would be great to see pictures of your install if you're willing. Brent

I too have been using 5 year old hardener without apparent issue other than color change. I'd suggest 205 hardener if it's less than 65F consistently and working in thin layers. Pot life at 60F will still be quite long, but at least it will cure. As a side note on mixing practice, I've...