Recent content by Joal Garner

hi all , just after the above prop , needs to be 2nd hand and shipped to New Zealand . Cheers

sebastiencaron , do you have a ops 67 pipe in stock , if so can you please measure the dia of the widest bit for me . I have brought a 2nd hand one but feel that it is a pipe for a 45 ops . can you please measure it in mm , that would be a big help if you could cheers Joel

Larry, can you tell me how you did the windscreen as I have one of these boats

thanks Tom

Tom , can you show a picture of them

that will be it then , cheers. I just had one of my mates measure his ops 40 pipe, its the same 40mm o/d . I still think it should be more thicker for an 67 motor

anyone got a titanium rod to sell , its for a drumed 67 OPS

Hi all , I have , well I brought a pipe off this guy and he says its an ops 67 pipe , but i feel that its too narrow at the widest part . has anyone got one that can give me some measurements in mm please

run a ride plate on your shaft , it works wounders

bunch of measurements,, diameter @ widest point, length from inlet to widest point,,, widest point to end of stinger,, stinger ID,,, ID of inlet? diameter @ widest point 45.13mm length from inlet to widest point 150mm widest point to end of stinger 183mm stinger ID 9mm or 10mm ID of inlet...

how much for just the kit un built . shipped to new zealand post code 4312 got any pics with a zenoha in it , ready to run

you stil got the Ab pipe

does anyone know if this pipe is for a CMB 45 , as I got it 2nd hand ( the person said it was off a 45 , but I just want to check before I chop the end off it ) cheers

Ok , will try that . were can I get a stinger muffler from . cheers for your help

Yep , Tom's the man