Buckshot's latest activity

Most of the people on this forum know of the term "end play". But, a lot of people on this forum don't really know what end play is and...

A new Yo-Yo! LOL Steve Ball

Terry, adding a shim to the crank will allow the crank to float rearward towards the drum. Maybe NG.....

Any way to measure the distance between the step at the front of the crank to the back of the counterweight? Then the corresponding...

I feel like I could have left them in, motor ran great before I took them out.

Some manufacturers do , some don't.

They were NTN. Tabbed. Yes I’m positive they are fully seated.

Actually still have them on the bench. Was thinking about taking them apart to see what the balls and races look like. Radius’ look the...

Now I’m curious!! Maybe also due to (2) different manufacturers!! Full disclosure, when I changed bearings mentioned above, Al only...

Perhaps the large bearing inner race I.D. has a larger radius on one side than the other and it's in backwards? Seen that before.

Not excessively. I think the big bearing pocket would need to be a few thou deeper to release some end play if desired, but so far I...

Not in F but you can in Twin Hydro. But .80’s are all you need. 🤭

I ran the test engine pretty hard with the bearings that it comes with and had no issues. The rod has not been modified, and it has had...

Wire drives should be set up with a little amount of bend as possible. No hard corners. The bend should be over a large area in small...

Zipp Kits sells .150 X.187 flex shafts, website says they are soldered, and USA made. I run them in my JAE 12 since 2016 w/o any...