- Joined
- Oct 15, 2012
- Messages
- 604
This may be an Andy Brown question
I am installing a 45 VAC where an rs was installed prior in a 45 SGX
Ask me why I am removing the RS, sometimes it is preference, not this time if i showed you a picture of inside of rs you would get it
Question is how far toward the rear of the boat can I place the VAC without seriously affecting the cg and handling
If i can get a satisfactory picture ill put it on here
It is definitely too far forward mounted where the rs was, very little clearance on middle bulkhead and tank. Thank You for any input
Richard Hartley
OK I uploaded the proposed after and the before pictures the position of the motor after I move it will be approximately .83 inch aft of original position
I am installing a 45 VAC where an rs was installed prior in a 45 SGX
Ask me why I am removing the RS, sometimes it is preference, not this time if i showed you a picture of inside of rs you would get it
Question is how far toward the rear of the boat can I place the VAC without seriously affecting the cg and handling
If i can get a satisfactory picture ill put it on here
It is definitely too far forward mounted where the rs was, very little clearance on middle bulkhead and tank. Thank You for any input
Richard Hartley
OK I uploaded the proposed after and the before pictures the position of the motor after I move it will be approximately .83 inch aft of original position
Last edited by a moderator: