- Joined
- May 17, 2004
- Messages
- 295
OPS 67 disc version, needle roller bearing in rod, Rod Geraghty carb(have set up instructions from Rod), 1/4 flex collet. This is the motor out of my scale boat and had good compression and bearing are smooth. Always flushed with Corrosion X. $185us shipped.**SOLD **
https://www.intlwaters.com/gallery/displayimage...&fullsize=1
Second OPS 67 is my back up motor, drum version, bushed rod and OPS slide carb, 1/4 flex collet. Good compression and bearings smooth. Flushed with Corrsion X. $175 shipped
https://www.intlwaters.com/gallery/displayimage...&fullsize=1
Third combination are for spares. One almost complete motor( compression is down) and one older style case with used piston and liner. $50 shipped or $10 if you buy second motor
https://www.intlwaters.com/gallery/displayimage...&fullsize=1
New OPS 67 slide carb. $40 shipped
https://www.intlwaters.com/gallery/displayimage...&fullsize=1
Paypal preferred
https://www.intlwaters.com/gallery/displayimage...&fullsize=1
Second OPS 67 is my back up motor, drum version, bushed rod and OPS slide carb, 1/4 flex collet. Good compression and bearings smooth. Flushed with Corrsion X. $175 shipped
https://www.intlwaters.com/gallery/displayimage...&fullsize=1
Third combination are for spares. One almost complete motor( compression is down) and one older style case with used piston and liner. $50 shipped or $10 if you buy second motor
https://www.intlwaters.com/gallery/displayimage...&fullsize=1
New OPS 67 slide carb. $40 shipped
https://www.intlwaters.com/gallery/displayimage...&fullsize=1
Paypal preferred
Last edited by a moderator: