steath assassin
Well-Known Member
- Joined
- Feb 9, 2007
- Messages
- 364
Is there a strut with a bearing out there for a 31" SD mono? I need one BTW...
Thanks,
Derrick
Thanks,
Derrick
Dave I have a new speedmaster strut assembly for that boat hull. I run shaft bronze bushing No bearings. Strut $20 bushing $6.50 plus 5.00 mail shipping in usa. please advise if needed. : Joe Warren 775 Crimson Oaks lane Collierville TN 38017.Derrick
Nice looking boat man...
Yeah speedmaster from offshore - just get the mono offset with the round bottom. That will work fine.
AS for motor.. I run a 1521/1.5d in mine. Its NUTS
I also tested a 1515/2.5d and i could run up to a 52mm prop.. Ran its best with a 447/3 on that motor.
Ran a MGM224 ESC with no water cooling on either setup for a long time. Got water cooling now in there as ive got some prop work and boat is just nuts and im not changing it one bit.
Dave
Derrick I have you covered if interested. see above post for info. thanks! jwJoe,
I dont need it but i think Derrick might be interested in it.
Cheers
Dave
Hey Joe,Derrick I have you covered if interested. see above post for info. thanks! jwJoe,
I dont need it but i think Derrick might be interested in it.
Cheers
Dave
yes.. New speedmaster rudder assembly 39.95Hey Joe,Derrick I have you covered if interested. see above post for info. thanks! jwJoe,
I dont need it but i think Derrick might be interested in it.
Cheers
Dave
I have been busy with work... Do you have a rudder also?
Thanks,
D
Enter your email address to join: