Search results

I'm going to build an 1/8th scale from a Dumas kit. What kind of replacement wood, and size, would you use for the deck and the bottom?

No time, no money, so it's time to sell. This is a wood hull built by Gus Johnson. Top quality paint job. Includes carb adaptor for side radio box set-up. Includes the rigging that you see in the picture. I can't seem to get very many pictures to upload here, so Email me for more if you are...

I'm needing to sell one of my boats so I can take care of a few things. It is on EBay as of today. Here's the link. http://cgi.ebay.com/ws/eBayISAPI.dll?ViewI...em=390053638254 I think this will work if you paste it into your browser. If not just go to Ebay and look for #390053638254

As a non-expert, I was wondering about prop choices for my scale. What are the positive and negatives between running a 3 blade and a 2 blade prop? I know it is best to let the boat tell me which specific prop to use, I'm just wondering about your opinions on a 2 blade vs. a 3 blade.

I'm looking for pictures of the nose of both the T-2 Bud and the 94 T-3 Bud (before the rebuild). Thanks in advance.

Looking for X457/3 and 1457/3 props. Ready to run. Anybody out there have any for sale?

Well, here's the stupid new guy question of the week. I have an older CMB .67 engine that I think needs a bit of work. When I turn the crank it does not stop from the compression like you'd expect it to, the piston gets to the top then I hear a sharp clicking noise....then no resistance...

Anybody have any? It ran in Hawaii in 1991.

Looking for some who can do the graphics for the Ultra Bold and Dash. ??

Can someone shoot me Dick Caspari's Email address? My computer puked and I lost all of my saved info. Thank you.

You'd think it would be easy, but I can't seem to find any of those orange exhaust header gaskets for my .67 boats. Anybody find a source or a cheat?

I'm looking for a salt water extension for a Hull #8808 Cowling. Most commonly known as the Tide boat. My model is from Thunderboat Reproductions. Don't care if it is painted or raw, new or used. I just need it to fit, I'll take care of the rest.

Anybody know of a source for some spring clamps for .67 exhaust couplers? Everything I see is either too big, or too small.

Does anybody know if there are any clubs in or around Albuquerque, New Mexico?

How much rudder do you put into your boats? Do you set your EPA all the way out, 80-100-120%? How much rudder (minimum) do you need to make the turns? Perhaps I should ask how many degrees does the rudder really need to move? I'm running Hull #7207, as the 74 Technicolor. I know many of you...

Ok, so how much tork is enough to turn an 1/8th scale? I don't want to spend $100.00 on a servo if I don't have to. I guess the same question would apply to the speed of the servo as well. Also, how small (low tork) can you go for the throttle and 3rd channel servos?

Where can I find them?

Looking for pics of the Miss Technicolor--need a few that show the driver, so I can paint correctly.

Looking for Bud type exhaust Tube for a T-3 Bud. 2 of them, if youhave them. :blink: Not the really short one, but the tube that extends to the transom that is cut at an angle....Hopefully you Bud guys know what I'm talking about.

Looking for a set, maybe 2, of rear wings for my Bud T-3/T-2.