Recent content by Mario Hutchins

Samuel, Bearings got here yesterday,,THANK YOU Mario

I new I would mess up the pictures I'll try again SprintCat.bmpSprintCat2.bmp

Back in 2006 my neighbor was moving and he ask me if I wanted a R/C Boat. My only knowledge of R/C boats before he ask me was back in 1971/72 when I was 16/17 years old I happened to be at Legg Lake where they were haveing a race. I parked my car and watched a couple of heats. I was blown away...

Don,will Do

I will take them, how would you like payment sent. Mario

I also built my JAE per plans and haven't had any problems with heat. I did fine a good grease to use called Greengrease http://greengrease.net . After a full day of running when shaft was removed it still had a slick coating od grease. Tried wiping off with rag ,still there. Could only remove...

Glenn, I'll take an apron also,and I need your PayPal again. THANK YOU Mario

Thank you everyone many good choices to pick from.Now I need to figure what I need and make an order. Thanks again,,Mario

Hi all, I destroyed my 67 rigger in a race incident last weekend and now going to try my hand at building a 67 size JAE. Where is a good place to get aircraft grade plywood? Thank you Mario

HAPPY EASTER all; I can across this website http://www.grossishop.com/ and was wondering if anyone knows anything about these motors. Check out their YouTube on their assembly and how they use magnets for the rotory disk. I've never seen this before and not sure how it works. Mario

I'll take it if you still have it,just need your PayPal info Thank you,Mario

PM sent,,Mario

PM sent

Can I also get a set of plans sent to [email protected] thank you

PM sent