• If you have bought, sold or gained information from our Classifieds, please donate to Int'l Waters and give back.

    You can become a Supporting Member which comes with a decal or just click here to donate.

WTB: CMB 45 and CMB 67

Intlwaters

Help Support Intlwaters:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Jay Stone

Well-Known Member
Joined
Sep 11, 2003
Messages
904
Want to buy. Before I order from Stu I thought I’d check on here first...

Looking for following:

Current model CMB 45 EVO Engine.

Current model CMB 67


I will consider a cmb 67 greenhead..

Please let me know if you have anything you’d like to get rid of, prefer new or extremely low run time. Thanks..
 
I have green head 67 basically new. Upon break the water fitting came off and it overheated. Scored piston. So I replaced it with a new piston and sleeve. Done some clean up on the porting bits it’s stock timing and not run since replacing them $400
 
I recently sold two RS45 EVO engines that were NIB for $480 each. I have one more new RS45 EVO but I pulled the head off and took the piston and sleeve out to look at it. I put it back together with a new C-clip and I will include some extra C-clips. $460 shipped to you USPS. Prefer Paypal.
 
I have green head 67 basically new. Upon break the water fitting came off and it overheated. Scored piston. So I replaced it with a new piston and sleeve. Done some clean up on the porting bits it’s stock timing and not run since replacing them $400

Ken,

I will think about it. Just had a person message me on a new in box greenhead for $400 shipped.
 
I recently sold two RS45 EVO engines that were NIB for $480 each. I have one more new RS45 EVO but I pulled the head off and took the piston and sleeve out to look at it. I put it back together with a new C-clip and I will include some extra C-clips. $460 shipped to you USPS. Prefer Paypal.

Steve, if it’s the new gold head EVO Rs I will take it. PayPal ready
 
I have green head 67 basically new. Upon break the water fitting came off and it overheated. Scored piston. So I replaced it with a new piston and sleeve. Done some clean up on the porting bits it’s stock timing and not run since replacing them $400
I may be wrong, but I was told that if these engines get hot or lean they will simply shut down (not advisable) before the type of damage you have described occurs. Anyone? Is this true?
I have CMB and Novarossi's in the stable and have had no problems. All boats have a remote controlled HSN. (priceless)
 
Unfortunately not, if they run too lean they won't be receiving enough oil and then something has to give. Often it's big end bearings
 
Unfortunately not, if they run too lean they won't be receiving enough oil and then something has to give. Often it's big end bearings
I agree with the lean condition. I should have omitted that. I blend my own fuel so I know what in in the tank. However the overheating in my humble opinion should not have cause the severity of the damage described. Send a boat in the water rich, it will come back. Put it it lean and you will more than likely be retrieving it. (Hopefully without damage) Thanks for the reply Andy
 

Latest posts

Back
Top