charles siler
Well-Known Member
- Joined
- Oct 29, 2011
- Messages
- 2,004
Ok guys looking for a couple of props ABC 2314 & 2316 Sharpened or raw thanks pass you guy's later Charlie
You can become a Supporting Member which comes with a decal or just click here to donate.
Charles,Ok guys looking for a couple of props ABC 2314 & 2316 Sharpened or raw thanks pass you guy's later Charlie
Hi Walt I'll be able to buy both if you still have them thanks CharlesCharles,I have the 2314/2 prop rawOk guys looking for a couple of props ABC 2314 & 2316 Sharpened or raw thanks pass you guy's later Charlie
thanks
Walt Barney
Tanks 2 U
Walt's Hobbies
Hi Mark I'll take two if have them still raw if you would thanks CharlesCharles,
What is the application? I have a few of the newer 2315's with 17 degrees of Rake.
If it is for a hydro I think this would be another good choice also.
Thanks,
Mark Sholund
Hi Mark it's for my 45 JAE twin that I'm building this winter that was a fast prop on my single years ago. The we're 2314 and 2316. Not sure what the difference is on the 2315 I would like a set of both balance and Sharpened please. Thanks CharlesCharles,
What is the application for the 2315's? 45 or 67 Hydro?
I just want you to know that the stock numbers on a Raw 2315 are:
7.50" of Trailing Edge cup at .7 radi
5.29" of Center Of Blade Pitch
58.25 mm in diameter
With 17 degrees of rake
If you want mm it is a 58 X 87 with 3.45" of nominal pitch overall
$51.00 shipped to you.
I thought you bought these all from Walt Barney? I would rather people call me,
PM me, or email me about orders, as I do not read all of IW everyday anymore.
I have been busier this year than any other in the last 14 years.
I have 3- 2314's in stock also? The 2315's are packaged up and ready to ship tomorrow.
Let Me Know Your Address Again Please?
Mark Sholund
My email and PayPal address is: [email protected]
231-590-3023
Sounds good Mark let's do that . A set of both B/S if you would. CharlesCharles,
I would suggest you break-in the motors with a set of 2215's,
and then step up into the 2315's when the motors are ready to
Rock & Roll. The 1.5 pitch ratio seems to be a very good one on
the JAE's in heat race trim, and the 17 degree rake is working very
well with controlling the lift.
Thanks,
Mark Sholund
Yes Allan you are right but not for a twin JAE. Depending on the drag you may have to cut down the prop to get it to work properly. Thanks for the concern AllanHi Charles I had sold my 45 Twin's MAC45 Best 2218 little rake for 45 twin good increase speed "smooth" than 2316 ( too big) hardly pull "drag " Good Luck!
Hi Mark any idea when you might be able to finish them up .Charles,
I would suggest you break-in the motors with a set of 2215's,
and then step up into the 2315's when the motors are ready to
Rock & Roll. The 1.5 pitch ratio seems to be a very good one on
the JAE's in heat race trim, and the 17 degree rake is working very
well with controlling the lift.
Thanks,
Mark Sholund
Enter your email address to join: