I have a Novak Explorer II that quits after a couple minutes of hard running in my 6 cell rigger running a 15T D4. I believe it's due to the thermal overload protector. Once she cools a minute, she momentarily turns on again.
The heat sinks pop right off exposing two banks of three metal tabs. Can I solder a separate brass tube to each of the two banks and run water through? Apparently, the two banks will short of connected directly, hence a separate tube for each. My Explorer II looks like this
View attachment 1262
The heat sinks pop right off exposing two banks of three metal tabs. Can I solder a separate brass tube to each of the two banks and run water through? Apparently, the two banks will short of connected directly, hence a separate tube for each. My Explorer II looks like this
View attachment 1262