strut height for firefighter .12??

[Rick Jacobson]

Need some help with the strut height for this rigger. I am using fuller hardware withe Octura V937 3 blade. Thanks Rick

 

[TomMoorehouse]

the standard fullers strut will likely be a little too short. you will need the cat strut if you want to use fullers hardware.

here is what you want to do:

put 3 of the shims under the rearfront sponson tube

have to boat on a really flat table.

adjust the strut so that the flat part of the bottom of the tub is parallel to the top of the table. The strut should also be flat on the table. 0 degrees

set the rears so that the tops are parallel to the table and 3/16" off the table.

attach the rears with servo tape so they can be removed. see the thread about removing the stuff... it is pretty good. I recommend what mike said to use radio box tape first.

hope that helps!

Tom

 

[Rick Jacobson]

Thanks Tom, just what I was looking for. Rick