OPS 90 3/16 collet needed

[SKCS]

Got the motor, but it came with 1/4 collet. Would someone have 3/16 collet for an OPS 90 for sale?

Thanks,

 

[[email protected]]

Your betteroff using a 1/4 cable. The 3/16 can break real easy w/.90's.

But if you do use the 3/16th, if the collet is the teist tighten one Aeromarine sells aconversion adaptor that fits right inside to make it 3/16.

 

[SKCS]

Thanks, I will go to the website. I should have gone 1/4 but the dual rudder assy I bought has 3/16 ferrel for the shaft support and the 60 that was in it had this shaft.

I will attempt with the 3/16 if she breaks I will replace with 1/4.

 

[Ray Sametz]

Dude, Set the boat up for 1/4" cable with OPS 90 will save you headaches. Good luck. Ray

 

[Don Ferrette]

I will attempt with the 3/16 if she breaks I will replace with 1/4.

104619[/snapback]

​

It will. :blink:

 

[SKCS]

Advice taken, will order 1/4 today.

 

[SKCS]

Would you have a pic of a complete OPS 90 set up. I also need a carb for this beast.

Thanks.