- Joined
- Oct 29, 2009
- Messages
- 667
I am looking at using a 7PX DL1 knob to adjust the remote needle, I do not see an option to do this. I KNOW folks are doing this, so care to share the secret to doing this?
Thx,
Paul
Thx,
Paul
Yea you wouldn't want it set to throttle trim unless you wanted it to control the low end trim on channel 2 throttle channel.Thanks Daniel, that part I did not understand was the "The full channel control for channel 3-7 is the third choice down in table of functions. Use channel 3 or 4" I did not think the Throttle Trim was the option to use... was looking for some general kind of function.
Paul
Enter your email address to join: