GiantScale
Active Member
- Joined
- Jul 19, 2002
- Messages
- 35
One more newbie question.. ??? ;D
My rigger will be painted inside & out. I dont want to have to drill out any holes after painting & "open" the paint job.
How much bigger do you drill the hole to allow for paint?
And..
I have many threaded holes also. 4-40 carb shield & cowl mounts. #8 wood screws for the exhaust bracket etc.. Should I drill these completely out? Then add epoxy after paint & rethread?
I will use sherwin williams 5 mil highbuild primer with U.S. paint awl quick filler on top of that. Then a single stage aerospace epoxy paint to finish so it wont be thin due to all the pinholes in the epoxy hull.
Thanks before hand.
Mike
My rigger will be painted inside & out. I dont want to have to drill out any holes after painting & "open" the paint job.
How much bigger do you drill the hole to allow for paint?
And..
I have many threaded holes also. 4-40 carb shield & cowl mounts. #8 wood screws for the exhaust bracket etc.. Should I drill these completely out? Then add epoxy after paint & rethread?
I will use sherwin williams 5 mil highbuild primer with U.S. paint awl quick filler on top of that. Then a single stage aerospace epoxy paint to finish so it wont be thin due to all the pinholes in the epoxy hull.
Thanks before hand.
Mike