happybradboating
Well-Known Member
- Joined
- Jul 3, 2007
- Messages
- 1,083
This 3.5 Hawk advertised needs to be assembled and comes with brief instructions from the original designer Gary Pruse with one page suggestions on how to build this rigger. In the instructions are recommendations on how to narrow up the hull to reduce weight.
The boat was slightly started by cutting out the side section pieces of the hull and then these parts were epoxy together as can be seen in the picture. The blue print diagram is in the background and is included. It also comes with complete instructions from Dumas. The kit has everything for completion of the hull with the exception one small block of plywood for the transom that can be measured and then cut to width. Additional running hardware is needed including turn fin, rudder, strut, motor, pipe, and radio equipment etc.
Selling price set at $70.00 and add 3% if paying by Paypal. Shipping will be calculated by zip code.
The boat was slightly started by cutting out the side section pieces of the hull and then these parts were epoxy together as can be seen in the picture. The blue print diagram is in the background and is included. It also comes with complete instructions from Dumas. The kit has everything for completion of the hull with the exception one small block of plywood for the transom that can be measured and then cut to width. Additional running hardware is needed including turn fin, rudder, strut, motor, pipe, and radio equipment etc.
Selling price set at $70.00 and add 3% if paying by Paypal. Shipping will be calculated by zip code.
