Search results

Starting to build a rc boatworks canard and need a cg staring point. Thanks

Looking for a 3 1/2 inch turbine tube for my 1/8 scale hydro. Want a light weight one either carbon fiber or fiberglass. Thanks for any help. Rich

Any help welcome. Where can I get the paint for my Joes hydro without spending a fortune. Thanks Rich

Looking for a like new one before I spend cash for a new one. Need a pipe and header also.

I ran this last season with no problems and put away oiled. Comes with all extra parts seen.First to say I will take it gets it. $300 shipped in cont US

Looking for a like new 45. I know I can get one new but would like to see if anyone has a extra one  Thanks

Need a pipe setup for my mac 45 in a PT sport 40

Got this a few years back in a trade. It was for the 2 motors and I never got a twin hull. Put the other motor in a whip after I sent the 2 motors to Huff to be checked out. This one has never been fired or mounted. Is a new old motor that was never used. Complete with pipe. Its a right handed...

Motor has almost new piston and sleeve. Other one is used. Header and pipe included.$325 shipped in lower US

Looking for a quickdraw motor package for a hydro.

Please pm with what you have. Iam ready to buy the right boat. Rtr is better but will buy without motor if set up is good.

I have a Phil T. Sport 40 with a Klass Kote paint job I want to remove. Can I use a stripper on it or do I have to sand it off?. Thanks

Garmin etrex that I used 2 times to get speed in my boat. I sold my boats so I dont need it anymore. Is like new and works great In a baggy in the hull tied down. Will sell for $60. shipped

New ss 6719 510 prop works west First $65 takes it,shipped.

Prop West 6719/3 654 New First $60 gets it shipped.

Really dont want to sell my best boat ever but I seldom use it and I need the money. Its got a fully modiefied 4 bolt zenoah that I sent to Carlos at CC motors to have done. Has a props work custom prop on it. It does 59 and 60 all day long. Rudder servo is a Hitec 645mg and it has a venom 1600...

I purchased this from Matt Hughes here on the dock and have never used it. Time to sell. I will let it go for $85 shipped. I will

Got 4 gals in qts. Iam not going to use. I live in Hoffman Estates Ill. and would like to sell local. $120 picked up or we can meet somewhere.

Brand new never in water. Just started for a few seconds. Rtr. Put in your rx and your running. Hull built by C Pines Motor is new as is all hardward. Finish is 2 light coats of Glass Kote Clear.Got alot in it. Stand comes with it. Looking for $800. You pay to ship Just the cost. Should be a...

Getting my rigger finally finished after a few years of sitting. Where is a good starting cg?