Search results

Maiden Voyage

Maiden Voyage

Maiden Voyage

Maiden Voyage

Maiden Voyage

Maiden Voyage

I was wondering if anyone could suggest someone who could perform some mods on my nib CMB 45 RS? I was going to try running it stock but if speed can kill, I'm ready to die. Thanks in advance for any suggestions. I appreciate any help I can get!

Hey Andrew......If you have a highly polished bottom on the boat you might want to scuff the bottom(parallel to the keel) with 150 to 200 grit wet or dry sandpaper. Lubricate the paper with soapy water so the paper does not stick to the bottom. The purpose of this exercise is to reduce friction...

Hey Jerry....could you tell me the dimensions of the holes in the rod? I have an old K&B 7.5(about a 1978 model). I don't know if it would fit or what. You can email a reply to me at [email protected]. Thanks, Jim

Hey Brian....I am looking for some rods for an old 7.5 inboard engine. If you can figure out the dimensions of the holes in the rods e-mail me and let me know. I might be able to use them to breathe a little life into my old engine.([email protected]) Thanks,Jim

Hey Rodney....I'm using the stock setup. Guess I will just have to grin and bear it. Thanks.

I needed to drill a hole for a #2 wood screw on the inside wall of my cockpit but there was not enough room to fit the drill. What I did was to get a piece of piano wire and chucked it up in my cordless drill. Being flexible and tough I could hold it and bend it while it was spinning without...

Hey Rodney...yes I am using the stock screw.

I am using brand new Duracell batteries.

Hey Allen....these servos are brand new so I doubt anything is broken. Thanks

Hey Rodney....the gears are plastic, there is not any metal to metal contact, the batteries are new alkaline, and the hookup is a straight shot. That is what has me illed out. Thanks.

Hey Allen....the servo is brand new so I'm guessing that there are no broken parts to blame. Thanks

Hey Jerry...yes it was the same model servo

Yes sir. Same servo, same problem. Thanks for the reply.