Search results

Hello all, I have just completed my first build, a Zipkitt Thunderboat and have fitted a brand new Zenoah 290PUM. Can someone please tell me the base setting for both needles and a correct run in proceedure. Also what ratio fuel mix do I use? I have Motul 800 2T oil to use. Cheers

Hello all, Do I follow the run in advice on the instructions? 2.5 turns out on the needle, 1 full tank flat out. Then lean it of 1/8 turn and run another full tank with a mixture of full and half throttle. Then take the needle back to 2.5 turns and run another full tank flat out. repeat for...

Hello all, I have bolted up the TT outboard and have installed the throttle servo. My questions is how do I mount the throttle cable and the plastic tube it runs in. What I mean is when I move the outboard from left to right it pulls on the throttle cable and adjust the rpm. How do I mount...

Hello all, Converting my VS1 to nitro, what size throttle servo do I use? Cheers

Hello all, Where can I get a balanced and sharpened X637 to suit a TT pro outbaord. Cheers

Hello all, Well I have taken the plunge after no sucess at all with a FE system on my VS1 I have taken the plunge into the world of nitro outboards. I bought a new Thunder tiger Pro as that was most of the budget gone. My question is about starters, do I need a 12 volt hand held starter or can...

Hello all, I have a VS1 running a proboat outboard with a 1900kv motor, I have bought a new nanotech 5000, 65-130 5S and was using a turnigy 180amp ESC. I say was because today was my first outing with the new 5S. I ran a couple of slow passes and then did two full throttle burst of about 5-8...