Search results

Hi everyone - I am setting up a pre-order to hold 1/16" birch plywood sheets for you. I will have 12" x 61" (5.08 sq ft) sheets available of the real 1/16" thick birch plywood for $18.00 per sheet plus shipping. I could probably get shipping costs down to $12-15 per sheet. That makes the...

OK so I know how the CG is calculated on a hydroplane/rigger. What I am interested in learning is what affects does changing the CG have on the hull? Rule of thumb is 15-20% of the after plane from the back of the sponsons, so what exactly changes when you have a rigger with 15% and a rigger...

I have read through countless threads on hydro setup and turn fin location. Many have said put the trailing edge of the turn fin right at the CG, other up to 1" ahead of it. Where should the trailing edge be in relation to CG? I know this may not be a simple question because it just depends...

Mansfield, CT at Mansfield Hollow Lake @ around 8AM June 1, 2014 Plenty of Nitro and Gas classes Drive East on Bassets Bridge Road, pass Hawthorn Lane on your left and as you come down the slight hill you will see a small turn around on the right side with a yellow gate. Open the gate and...

Anyone have access to the manufacturer setup specs for the Roadrunner or Hurricane riggers? Gas hull is desired, unless the smaller nitro hulls use the same exact setup. Referring flat surface or setup table specs. Diagram helps too

Looking to buy a mono hull boat mold. Interested in gas boat sizes 45"+ or something similar. Let me know what you have mold can have "some" damage Aaron

OK so you have the same AOA degree for example 3 degrees from water surface to bottom of running surface at speed. But the top of the sponson is either parallel to the water line or angles down (closer to water line in front than rear, no parallel) at speed. What would be the reason for each...

Hi, I would like to extend my radio box services to this community. I have been building custom radio boxes for JRCBD members for a few years. Please visit my website for all products and more information: http://www.aaronhl.com My radio boxes are built with baltic birch plywood, sealed with...