I'm running a hydro w a etti hv esc and a neu 1527 1.5y motor octura 450 prop on 10 cell and the boat revs out w no load but when I put it in the water for the first time today it can't Rev up.... If I hold the prop out of the water then pull full throttle and hold it, then drop the boat into...
Can someone tell me if it matters what side of the strut the rudder goes on if the turn fin is on the right side and what the difference would be in performance?
Thanks for all the really great ideas. They have helped a ton. This is my first large hydro and figuring out some of these small ins and outs are tricky.I'm sure I'll have a few more as it comes along
Did you use 2part foam to fill the wings? And do your bolt going into the top wing just thread into the side of the top wing itself or did you add a nut or aluminum inside the top wing?
When the bolts go threw the side wings what do they thread into on the top wing? Also What do yo guys add to the wings to make them float or do they float on their own?
Since we're on the topic of rear wings. Do you guys use nylon screws for the top portion of the aluminum tube brace that runs from the transom up to the top inside of the wings? And stainless screws to attach the aluminum tubes to the transom?