Recent content by Swissrigger

Hi Gilbert, I am sorry for Michel. It is a while ago I met him the last time, he was still fine. Can you pass him my best regards? Best regards, Petr

Salut Gilbert, Are the .90 rigger and the engines coming from Michel? Have fun! Best regards, Petr

Dino, If I cannnot get the pin out on my .21 engines I do following: 1) Remove the nut on the pin 2) Heat the engine to about 320°F in a stove (preferably just the crankcase without bearings etc.) 3) Take the hot engine and grab the carb body with a wrench just to have a lever. Rotate the carb...

Tony, I will take the Prop Pitch Gauge. You have a PM Best regards, Petr

Tony, Do you ship to USA only or would you ship to Europe (Switzerland) too? How much is the additional postage? Kind regards, Petr

Walt, you have a PM, Kind regards, Petr

Swissrigger, on 10 October 2012 - 06:05 PM, said: Charles, Do you have plans to make a batch of the Zoom Carbs for the NR21 ? I would take 2 of them. Availability?? When? Price?? Kind regards, Petr Hello Petr, I have a batch of NR 21 and Vac 21 Zoom carbs that should be ready in the next...

Charles, Do you have plans to make a batch of the Zoom Carbs for the NR21 ? I would take 2 of them. Availability?? When? Price?? Kind regards, Petr

Charles, Are the ZOOM Carbs for Novarossi .21 available again? When not when doe you expect to have them ready? Price $$? Kind regards, Petr

Jon, Converting car engines to marine is very common in Europe. Car engines are much easily available compared to marine engines (I refer to Novarossi). Just looking on Novarossi homepage you will find so many different types of car engines with different sleeves, pistons (flat, hemispheric...

Mike, What nitrosniffer is describing is a general procedure to convert a car to a marine engine. On my I leave about 5mm of thread. I cut the front part of a Novarossi flywheel and use the collet unchanged. Petr

Terry, No problems with overheating. Enduro racers (FSRV Naviga) race them (geared) in heats of 30min without problem.. Regards, Petr (Switzerland)

Waltr, This silicon ramp is very sensitive (gets damaged) to many cleaning oils like WD40. WD40 will blow it to a balloon and it will get loose. So far I know Corrosion X has not this adverse effect. Regards, Petr

""This spoon experiment demonstrates the Bernoulli Principle. This is what the bottom of a "rounded" riding surface does when you try to turn a boat. This is what causes a hydro to "nose steer".a tunnel boat to "hook" and a mono to "spin out". Just very lightly hold the spoon between your...

Hi Don, The pipes are using a really interesting concept. May be I missed who is manufacturing them and where are they available. Are smaller sizes also available? Thank you. Regards, Petr