Scott Tonak

Many moons ago, Salisbury offered a carbon pipe for gas engines. It was all the hype at the time but as I recall, had very little success.

I've got a similar setup just about ready to hit the water. Wendell leg, omen 29, Alan Terry pipe, custom cowling in kwaka green.

Anytime Thanks! It's not a wrapped pipe. It's all welded steel. Very well done.

Hello Neal, I set the boat on a flat board and set the front of the strut level on the board. The boat runs pretty flat with the cg at...

Jeeez..... I ran analog 4.8 futaba servos for years on 6.0 nicads... never had servo failures.. hell, some of my old boats still have...

I've been using Promodeler standard size servos in all my gas boats for years now with no problems at all and I really like them...

Imagine that Scott! A little birdie told me and it seems to be the only one that works in the FL heat and humidity but we're getting...

Looks like you guy's got them boats running really well! Where in the world did you ever get the idea to put a 2719 prop on those? Great...

It's a very low lift prop so you might have to tame it down a bit depending on your set up

I will give it a try I will have to order one up I was thinking on it but wasn’t sure

Bruce, try a 2619. That was my favorite prop when I had my whip with a 27. High rpm with lots of push.

The boat is an original ML Boatworks gs480. The kit is now sold by PTI Racing as the gx480. Wendell Barrow lower unit, SS Racing Engines...

Just starting to get this boat sorted out and learning how to drive this beast. It's been 20+ years since my old nitro outboard days...

Even if they're labeled "waterproof", no matter the brand, I always take them apart and put a little silicone around the rubber grommet...

Bh Hanson 30.5 power...went with the speedmaster square drive on this one. Ready for some testing