Recent content by Matt Davis

I also unhooked the killer bee to see if it was reading anything but perfect to prevent spark and it still didn't spark. Thank you all so much for your experience! Now is that red the positive for the coil and black is grounding wire I'm assuming? Should I just ground them for now with wire you...

It looked like a solid connection, but the wire stabbing through seemed a bit long, I'd say at least 1 /16 " past the base of the wire itself and it wasn't stripped and wrapped along the base of the coil wire itself just a stab through

New plug grounded on the head not the aluminum cooling jacket and not even a small or weak spark just nothing. Has fuel has air, has compression, no spark

Changed the spark plug before testing seems the wire is getting no electricity through it, gonna try what a buddy of mine said and ground the coils together. What size wire or resistance would you wonderful people recommend to ground the coils. Also disconnected the kill switch too see if fault...

And trim the base idle on the radio to around 4k? The standard idle was set around 2.8-3.2k and was stalling rather easy but the slightest touch of the throttle kept a decent run

I've been talking to some friends that race and have amazing collections, but I've been gathering as much info as possible to be safe. I've got a built 300pum with a 1027 and online the base settings are 1 1/4 H and 2 L but my buddies and racers I know have been saying start at 1H 1/2L but for...

Was in pool under load pumping water, has same compression and I didn't see spark on basic spark plug it came with I got 5 upgrade CMR sparkplugs for the toolbox and have amsoil pro saber 8 oz in tank, I'm assuming it's definitely the spark plug but it is a 1027 not a 1048 I was incorrect

2 mins while holding and slowly raising rpms to about 6.5k or 1/4 throttle and letting off with propeller load

I'm hoping it's just a bad plug gonna order some and check for spark before all that stuff

Worst case it did shear how much of a pain in the ass is that to fix?

First start to in pool fired fine 5-6 times low idle stall but fired right up, took it to the lake rented a boat to give it a proper break in fired right up ran for 15 seconds and the base tune they said not to touch until a tank is ran through ran so rich it it flooded itself while running. The...

My fountain 64 showed up and it's way bigger than I expected lol Fully build billet engine 300pum and some other tech goodies, can't wait for the weather to change and get it to the lake, first started in my pool yesterday and it screams !

Ignore the mess installing new fish tank at the same time kinda crowded

Still in ohio till about October, but will definitely get a rescue boat in that instance lol