Recent content by magsden

Hey Grim, Sounds like a great time. I'll be RVing it but will be haulin' the bike. Will definitely make the party. Bring on the karts!!! Now I just gotta get the boats up to snuff. Looking forward to meeting everyone there. :D :D :D

Thanks Kevin - On order should have it this week!!!! By the way that CMB LS I bought from you a while ago is running sweeeeet on an HTB 290. Just need to settle down and learn to drive. :o :o :o :o bouys beware

Or anyone else that stocks these. I ate a bouy and the bouy ate my pipe. I need one to setup before the Internats. CMB .45 RS in a Seaducer.

Hi folks, Yea I need help. My sport tunnel that I was going to use for the Nats. just isn't going to cut it. I have had lots of help trying to get the thing to act nice on the water. The thing just plain feels it has to hop up and down at speed. I decided to build a JD WOF 30 and have started...

I just got a new Seaducer with a .45 CMB RS. set up. 450/3 prop - Hitec HS645MG steering servo. When at speed I try to turn, the boat just cranks into a tight turn and will not straighten until I let off some throttle. When I do let off the boat quicklt cranks the other way because I'm not quick...

Thanks Dave. Iwill check the prop shaft. The prop was purchased as balanced and I haven't bought a balancer yet. Hope that is not the problem. Guess I better get one of them thar balancin' widgets too!!! Wife don't understand all the whys and whatfors of this stuff. Just haf ta say cuz I need it...

Thanks jdyracing, I'll get to that tonight. Gettin' to be a real pain replacing those shafts. I'll try the oil thing. You just fill from the top before each run? Do you plug the holes at the bottom to keep it in?

HTB 290 with CMB LS and Lawless with Strongarm shafts. I grease the shafts with Mercury outboard grease after every heat and I only get about two heats before the shaft looks like it is starting to spin near the prop end. Is there something else I should be doing beside buying caselots of these...

Hi all, I just sent my entry in. 3 boats, also need an RV site. It's up to the USPS now to get it there on time!!!!!! My pit crew backed out on me and I will have to rely on some good folks around there to count to six for me. Not the best way to do it I know, but I want to be a part of the...

I've got a .45 RS in a new Seaducer. I have not gotten it broke in yet but it appears to run great so far. No problem turning a 450/3 or a 452. I'll post later after I have a few tanks through it.

Thanks Clay. Thats what I needed.

Does anyone have a phone no. for Jerry Crowther or a supplier for a new SD3 .45 Mono? Wanna try to get one wet soon.

Tuned pipe setup and prop selection/customizing would be great. I have a .67 cat and some hull specific stuff would be great also.

Nice lookin' boat zrwhat.

I would like to go out and drive back in every race without dunking my radio box. I bought into the JR synthesized system and would hate to replace a $70 rec. every week. Really though, I would just like to learn to drive again and finish races without trying to win too hard. The points game...