The lag screws going up into the motor plate, attaching the lower leg.
One of the four is partially stripped. I don't torque the screw in that corner at all. If I cranked hard at all on that corner the hole would completely strip out. I think that having to disassemble the leg several times has...
Would this change in material help to lessen the chance of stripping out the holes with screws?
If it will, I think the change (and bump up of cost) would be a good idea. The market is going to grow for these lower units.
Sounds complex
That is an understatement. :D
Wouldn't it be fun to have R/C boat racing operating like the ABRA does now?
Them N2 Violations just make the racing so exciting!
A half hour after the heat finishes, you find out the boat that finished first actually was disqualified. Excitement...
And, we'll be back resetting the limits, ad nauseum. The technology is constantly evolving and so will the limits will constantly be evolving. Unless you want to freeze development.
Easy to tech? Not hardly. Variations between scales alone would make this one a nightmare. Does the scale in...
I'm a bit confused here. A little disoriented.
Could somebody please point me towards the "bickering" section?
What's going on here is an exercise of freedom of speech and a debate of issues. This isn't a bicker session.
The only thing even remotely appearing like bickering, is that one or...