John Beardslee's latest activity

Grim may not have seen this so I’ll add my 2 cents which may or may not be exact. The jist of it applies to Corrosion X or other...

I think what Grim is referring to is an old glow plug to run the engine with when you first start it after using your after run...

If you are running Nova Rossi engines WD40 and Marvel Mystery oil will dissolve the silicone ramp in the crank so other choices are...

Rick, I’ll take 2. Thanks, John

Humm, I used to buy regular CA in pint size for our Bru-Lin antennas. I’ll do some checking, it’s been years. What kind of foam are you...

I’d go to Bob Smith Industries, they do most ca for the hobby shops that have the shop name on the bottle

You’ll want the stiffer rubber if available. ie: higher durometer or shore number.

I think they are 1/4” ID x 7/16” OD for a 1/4” panel

You delivered quite a few didn’t you.

That’s a Michigan Alky boat but I don’t remember who’s number.

The dog bone U joints had to be perfectly aligned and supported plus with the steering strut the pivot had to be dead on or it would...

It didn’t have a rudder, just the steering strut, the steering strut had a skeg like an outboard. Never had any prop walk that I...

Oh, Bill, it’s not a DragnFli but a scaled down model of a 14’-6” Enthrop hull. K&B 40 series 70 pylon engine with a Kool Klamp and...

I would think just building one with a flex cable drive and adjustable strut would make light years improvement over the original set...

Rick, check your pm’s. John