Recent content by Jamesbon

next...

Well, here she is in all her glory. This is the one where you guys helped me water cool the Novak ESC to prevent the thermal overload from kicking in.

next

next

next

next

next

next

Just glad to finally contribute... :) A neat hydro I picked up for tiling my buddys hallway. Don't know much about it other than it's intended for a .40 engine...I hope to find a gas engine small enough to cram in there. Next is the offshore .21 size glass hull I scratch built, including the...

Nice! I like the classic look. What hull did that originate from? ...wouldn't mind having one of those...

...Update... Lowering the front sponsons helped as did the X435 prop. She close to being dialed in now. After an early morning run today, I noticed the insulation on the positive wire between the ESC and motor was slightly distorted from overheating. My bullet connectors are tight as is the...

So, after helping a friend tile his house today, he offered me a fiberglass sport 40 hydro instead of cash. Being the boat fanatic that I am, I gladly accepted this righteous looking un-rigged beauty. Neither of us know who manufactured her, but she appears to be a true "Miss Bud." type looking...

Well, it worked. I finally ran the rigger through a 6 cell pack without the thermal overload kicking in. As stated before, I drilled the purple heat sinks, ran 1 piece of brass tube through each set of fins and connected them in the middle with fuel tube. I think I need to push the rear of the...

last

another...