Recent content by Chris Lina

Kalistratov 67 marine engine water cooled head and exhaust header, brand new, never run, never mounted in a boat, never had fuel run through it, pristine condition. Purchased new from Al Hobbs in 2002 and never used. Also includes; K-67 needle bearing, K- remote needle valve, spare new front...

I just want to say you guys are something, freely sharing your knowledge and willingness to help. Thank you. Greg- Youe bottom shots of your Qatar are fantastic alot of good info there to work from. Mark- The dimensions you provided should be extremely helpful, along with any other info you may...

Thanks to all for your responses, I've got about every picture ever taken of the transom details of these hydroplanes but unfortunatly without actual dimensions or a dead on overhead shot it is very difficult to design an accurate rendition of the rear end of these boats. I need two dimensions...

I've got a couple of questions for the scale unlimited experts. I'm planning on building a scratch built 1/8 scale cmb powered Peters & May U-11. I have already scratch built the U-8 LLumar from Newton plans so I am not a total novice. I am an exact scale freak so I want to duplicate the full...

The web site to Laird Plastics is; www.laird-plastics.com. On this hull getting the rounded sheers on the sponsons was tough. I just sanded the pointed edges until they were rounded which was not enough. I am in the process of designing and building the new 2003 or 2004 LLumar now and I am...

Hi guys, I have built the 2000 LLumar Window Film from Newton plans using G-10 epoxy glass sheet, back in 2001. The material is a pleasure to work with; semi-transparent and can be cut with a small tin snips. The glue I used was 3M Scotch-weld 2 part epoxy mixed with flox, ( cotton fiber)...

I'm also interested in more details on that turbine engine. A lot more info would be appreciated. Thanks