irwin pipe 6080

[Ted Moes]

wtb a Irwin pipe 60/80 and header for picco 11cc motor

thank you

Ted

 

[Mike Byer]

Are you looking for an early Irwin quiet pipe? I'll see if I can shoot a pic of what I have, should have a header too.

 

[Ted Moes]

thank you for looking, my friend says i need the flat backed pipe if you have 1 + header

here is a pic of my motor which im rebuilding.

 

[Mike Byer]

What type of boat are you going run this engine in? Makes a difference on the angle of the header.

 

[Mike Byer]

Here's what I have to offer. Pipe with welded on mount tab, and pressure fitting installed, and you choice on the header high angle for a mono or low angle for a hydro/rigger. $60 shipped to the lower 48. I'll include a spring and a seal. I can help you out with a better carb too.

mb

 

[Ted Moes]

still trying to figure out which is right pipe for mr pringles u-8 1986

how much for carb

 

[Mike Byer]

You need the low angle header for a scale, $10 for the carb.

mb

 

[Ted Moes]

Is one of those headers the low angle

thanks

ted

this is the boat that is being rebuilt

 

[Mike Byer]

Yes, 1 of each in the pic. The pipe is 11 3/4 over all, with the header shown it will make a length that you can work with.

mb

 

[Ted Moes]

can you send me an invoice

 

[Ted Moes]

is the carb an OS

 

[Mike Byer]

No it is a modified Picco carb with a remote manual needle. In the pic of your motor your carb looks to be a slide type, my carb is a rotary barrel. My paypal is

mbawks@ aol.com

 

[Ted Moes]

What is total amount with carb and pipes and do you happen to have any exhaust gaskets

 

[Mike Byer]

$70 shipped to you, if you are in the lower 48. Yes I will include a seal where the header meets the engine and a spring to hold it on, along with the pipe and the low angle header, and the carb with a remote manual needle. I'll send some silicone tube to connect the header and pipe too..

mb

 

[FloridaScaleBoater]

Mike, you sure are good to people in our small hobby.

You are ALWAYS willing to go above and beyond to help folks out.

STAND UP My friend

Ted, do you now the make of your Pringles hull? IS it fiberglass or a wood built hull.

Could you share some interior and bottom pics

 

[Ted Moes]

Its a newton fiberglass hull that david newton ran himself

will post some photos today in my scale album

 

[Ted Moes]

Thank you so very much Mike, I sure appreciate the help you have given me as I am such a newbie

 

[Mike Byer]

PM me your shipping address, it does not show in paypal when you send as a gift. I'll put your package in the mail on Tuesday.

thanks,

Mike Byer

 

[Ted Moes]

Mike

this big diameter pipe is not going to work doesnt fit under the rear deck

ted

 

[Mike Byer]

It's what you asked for and what's in the pic, but if it won't work, you might offer it for sale, if there is no interest, I'll take it back. Can you use any of the other parts?

That isn't a very large diameter pipe for a 67 pipe, really one of the smallest, I'm not sure what you could use if it won't fit

mb