Search results

Those are 8848 but you have to buy a 9 pack. These may work the same as they look similar and believe I have even used them before. I have used so many different boots over the years. Some are a bit long and have to be trimmed to fit but those work too...

The red Zenoah boots seem to do it even worse than cheap China knockoffs. More real silicone in the red Zenoah boot probably the reason they are more susceptible to it happening and they are pretty thin just above where the sparkplug tip comes up through the spring with a flat top. The others...

https://www.intlwaters.com/members/lohringmiller.22688/ https://www.intlwaters.com/conversations/add?to=LohringMiller

https://tools.usps.com/go/TrackConfirmAction?tLabels=9400111105500589934551

Doug, Just need your address again please sir. Thank you.

The ends of the brass ramps are slotted so you can add as much up trim as you want in the turns. All K&B 3.5 outboards were raced with this system in them when I started. One of my boats in 1974 this all wood modified Dumas Hot Stuff had the system installed.

I have one complete starter with 75/150C battery pack and charge cable ready to ship. $385 Paypal is [email protected] Thank you, Daniel

Doug, I have only two 1800's like these left but no 2500 to fit transmitter though. 2 for $50 shipped. Paypal is [email protected]

Almost certainly a pin hole in the silicone boot. The spark can only jump so far. Usually where the canopy has smacked the top and the tip of the sparkplug knocked a hole through the boot. The quality MSD boots are a lot tougher silicone than what the Zenoah red ones are made from. They are...

Velcro right to the underside of the lid. That way all of the antenna is up the tube and no delicate coax around any of the mechanics nor do you have to mess with the antenna and tube because it stays up in the tube when you have the box open. Allows the receiver to be up and out of any water...

Those will all plug right into standard Futaba universal J extensions.

Tom, Try Bruces or if you want to try these. They are 50 lb. I saw some same dimensions only 31 lb so I recon these are stiffer than those. Lol...

The Lords or more specifically the Lords Speedmaster uses are a very soft isolator. If your looking for hard those will not be it. Bruces rubber isolators are probably some of the hardest you will find easily. Have both new sets in my hand atm and Bruces are much stiffer than the Speedmaster...

It won't hurt the cap orings any as they seem to be fine with petroleum based getting to them. The castor goes through the engine and all it's seals so cap orings should be fine as well. The little soft one at the top seams like silicone but I don't think it is as I have never seen fuel/oil...

If you have any capacity to the tank your going to want shut off valves

Steve, I can get the ZippKit collet tool made up and flywheel puller I have ready. Please send the $56 to [email protected] Send me your address too please. Thank you.

Ken, I can make you one right up for the fine thread Zipp Kit collet. They have been fine thread for about 5 years now. Originally, they were a different coarser thread. $34 shipped. Paypal is [email protected] Thank you, Daniel

Al has the 6002 as well I think.

Thinned enough to spray it would not be nearly as good as 2 part epoxy paint would be. Thinned enough to spray it may not have any strength if it even dries properly. Then since you still have to paint epoxy you would still have that step to go anyhow.

Rick, I just sent you Ronnie's address.