I use atf mercon or dextron as after run oil in my ramped engines, never had any problems with the ramp swelling or coming apart, i dont think the ramp is for wot only, i think it helps when milling mid range throttle and wot throttle. Rc 90 boat.
I totally understand the measurements at 90 degree intervals is this telling you your bearing races are out of round or are the ball bearings are not all the same size? pre loading a bearing weather it be spring loaded or mechanically loaded eliminates most of the radial runout also, on a...
jim do you have hot and cold readings for your radial runout readings on bearings? also do you take measurements with the bearing pre loaded or free wheeling.
The best thing to do is get the boat wet and run it and see how it performs some pics would be helpful also. There are a lot of rc boaters on here that will be willing to help you if you had some pics or video of it running. I have a miller american dumas kit that I have won some tropheys with...
in my 19 years of rc boating I have never seen one sold once people buy one they hold on to them for dear life because they run so good in race water, I have one but will not sell it it is a blast to drive. I think they called it the intruder. rc 90 boat.
what pressures are our fuel tanks running at in psi or inches of water collum. say at wot and milling, also what is a good way to hold a steady tank pressure? one way check valve, .020 orfice in pressure tap line, our engines are allways running rich and lean depending if you are milling or...
From the remote needle to the spray bar the fuel is not a solid stream of fuel the fuel just kinda trickles through this section of fuel line so why does this section of line have to be large id? I allways liked the old style carbs were the needle is right at the spray bar I think they work...
I disagree that larger is better also, especially pressure tap line to tank when you let off the throttle the tank pressure is lost quicker due to larger id of the line. with the correct id line the tank holds pressure longer , I have noticed this when milling.
don is 100% right torsion bar suspension is the way to go. on leaf spring trailers with double axels the tri-angle leaf spring equalizers allways rust and hang up causing one of the axels to hang up causing flat spots on the tires. I have seen this in my fleet trailers at work. rc 90 boat
Has anyone ever used carbon fiber motormount plates in a 1/8 scale,I have the rubber isolators mounted in the bottom of the boat, also would a carbon fiber rudder work, I am working on triming some weight from my 1/8 scale boat.