Search results

Where in the best location for prop wash pickup? Prop center/above center/ below center ?

Sounds like a crook and that’s why I buy at the local hobby shop.

I’ve single point machined acme / buttress/api oil pipe/metric/ British/UNJ controlled root radius aerospace/and 🇺🇸Threads for decades. Very good advice from your fellow model boaters. I rather make my own parts instead of buying 🏁🏁🏁🚤

I have a new spectrum MXR200 stock receiver and cannot get it to bind. Any advice?

Why do props have .008 to .010 thousands clearance over the shaft diameter (.250)? I think a balanced prop that is not a slip fit to the shaft would not run concentric and result in excessive vibration and wear on the strut bearings/bushings. Any advice or suggestions?🏁🚤

I’m looking for a 2 blade prop for a Zelos 48g with a Zenoah 30 stock engine. It came with a 67mm x 1.8. 3 blade. Any suggestions?

Any advice on changing stock 1.8 pitch 3 blade to a 1.74 pitch 4 blade or 2.6 pitch cleaver 4 blade on Zelos 48” gas 30cc. All are the same diameter 67mm