Search results

Is it adaquate for a gas engine. If so i will take 3 . thanks rich barile

thanks I'll follow up.

who is selling them ,  if anybody ?   thanks rich b. 

Who is selling them,  if any body. rich b .  thanks

Richard barile 140-22 poplar ave flushing, ny 11355 718 539 2266 Wil send pay pal shortly thanks

i would take both ,  250 you pay shipping  rich B. phone 7185392266

JOHN, NEED 3 TANKS, APPRECIATE A CALL. RICH BARILE 718 539 2266 ITS MY CELL CALL ANY TIME. TALKED TO MIKE C. IN SUMPTER LOVES YOUR WORK THANKS

Is there any stress releaving to be done after making the rod , or ruff cut then stress relief. ??? Rich B. thanks. appreciate any input..Press fit bushing heating to what degree. or not??

Mr. Schafer sent the props. Tried them at half a deg. N. G..put heavy load on the engines and they quit immediaty. Spoke to Schafer he stated 1 to 2 deg is sufficeint What he suggested is cut the middle of pad out so to get more adjustment. Got my 1667 finally runing with a bar cut and...

I"ll take all three call me 718 539 2266 Rich barile

Dont think I can get the 5/6 degrees ski is already in place Is it worth the effort for the speed increase and stabiltiy???

Have twin eagle with rear ski pads , no rear sponses. Will abc props work cleaver type, Im running 1667s with considerable lift. abc cleaver type have considerably less lift. I can not drop my strut , only can angle , will it they work??? appreciate input Rich B.

Like to purchase your setup , give me a call for address rich barile 718 539 2266 thank you.

WOULD LIKE TO BUY THE 2 AA PIPE IF OK CALL 718 539 2266 Rich B.

Sam sent you a email on your mac 67 How much and can you call me Rich B.

mac 67 case gets too hard to line up porting after the bore procedure especially front transfer near exhaust , tried it once. Have to take out alot of case material. Exhaust going to pipe is smaller also, as you bore out the case the transferes and boost walls become further apart alot of...

Will the mac crank fit in the bearings and line up to the rod ?? And the sleeve, slip in properly?? Boring the case no problem . Is the bolt pattern for the back end the same?? Dont have cmb case on hand trying to see if its worth the effort.

Cracked a mac 84 case actually a few over the years. My question is would a cmb 80 case accept the mac 84 internals. I know the stroke is 1mm longer on the mac, but will the mac crank fit the bearing is my main concern. The sleeve i can do a shim under the lip. The liner I think will...

It sound like its on your lap top after the run. I talking on your transmitter screen or a readout screen for eagle tree while running. I have a futaba 4PLS with tele. and get one reading . On my twin I have a switch and servo to go sensor 1 or 2 while im running, Rich b.