Search results

Intlwaters

Help Support Intlwaters:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. D

    Run in stand/dyno build.

    Terry, try changing the pipe length or better still change to a different pipe but keep plug to start of stinger the same length then see if the dip is still there or moved to a different rpm. That way you will know if it is a problem in the drivetrain. My experience is that it is all in the...
  2. D

    Run in stand/dyno build.

    Terry, Take care with your automatic needle setting vs EGT. As soon as an engine starts detonating the EGT drops and your system may well lean it out more, and then BOOM.
  3. D

    CMB 90 - Geared or Direct Drive

    In Europe virtually all racing surface drive monos 3.5cc and 7.5cc use gearboxes for the simple reason that they are faster than direct drive in the oval races here. The bigger props are more efficient and give better bite in the rougher conditions that we often race in here with up to 10...
  4. D

    THE BEAST!

    On nitro engines.... 1. On a rigger the pipe is being cooled by the airflow as you go faster. That is just what you do not want.  2. Pipe design. In general,  a short steep angled rear cone will cut off the power after peak. A shallow rear cone angle will allow more over-rev. On gas...
  5. D

    THE BEAST!

    Yes to both. 
  6. D

    THE BEAST!

    Terry,  When your boat is running at it's maximum speed it is well past the rpm point of peak hp. 
  7. D

    THE BEAST!

    Better peak hp and most important over-rev. but trying to maintain a decent torque curve at the same time . 
  8. D

    THE BEAST!

    I have not used a one way bearing on either of these dynos. At first I would blip the throttle when the flywheel was slowing down after a run, but in practice the flywheel disengaged pretty quickly. If there is a brake on the flywheel then it can be slowed very quickly. One of those things where...
  9. D

    OS 21XM Mk1 parts needed

    Andy, I have conrods for that motor http://www.prestwich.ndirect.co.uk/OSengines.htm
  10. D

    Boris Mazor passed away

    RIP Boris, a true innovator.
  11. D

    Gen-4M flow meter are back

    Boris, I will just have to suck it up. Please let me know the total and your PP address.
  12. D

    Gen-4M flow meter are back

    Boris, I would like to buy a flowmeter shipped to UK.
  13. D

    CMB Alpha carb

    I had most success with the ignition at set at 1.2mm BTDC.
  14. D

    Bushnell radar.

    Terry, GPS the telemetry rx and gps unit is too big for the 3.5 rigger and mono
  15. D

    Bushnell radar.

    Terry, I run normally with rpm and speed telemetry using the Multiplex radio but not logged, just max speed, actual speed and rpm on the screen.
  16. D

    Bushnell radar.

    Stalker it is then
  17. D

    Bushnell radar.

    Is the Bushnell 101911 radar gun any good for rc boats?
  18. D

    WTB. Zoom carb for Novarossi 21 and CMB21 Beta

    WTB. Zoom carb for Novarossi 21 and CMB21 Beta
  19. D

    JAE 45 ski angle and width?

    Did a search and found the info I needed
Back
Top